Pool Vacuum Hose Adapter Kit for Intex Adapter B - Fits 1.25" & 1.5" Above Ground Pool Skimmer Hoses - Includes Rubber Connectors & Clamps - 2 Pack

Pool Vacuum Hose Adapter Kit for Intex Adapter B - Fits 1.25" & 1.5" Above Ground Pool Skimmer Hoses - Includes Rubber Connectors & Clamps - 2 PackPool Vacuum Hose Adapter Kit Replacement for Intex Adapter B Key Features Universal conversion kit designed to securely bridge connections between different sized above ground pool hoses and pump fittings. Includes heavy duty, flexible rubber step down connectors that conform to internal hose ribbing for a tight, vacuum sealed fit. Features marine grade stainless steel worm gear hose clamps to resist rust, corrosion, and continuous saltwater or

Pool Vacuum Hose Adapter Kit Replacement for Intex Adapter B

Key Features

• Universal conversion kit designed to securely bridge connections between different sized above-ground pool hoses and pump fittings.
• Includes heavy-duty, flexible rubber step-down connectors that conform to internal hose ribbing for a tight, vacuum-sealed fit.
• Features marine-grade stainless steel worm-gear hose clamps to resist rust, corrosion, and continuous saltwater or chlorine exposure.
• Accommodates both 1.25-inch and 1.5-inch diameter plumbing lines for seamless integration with existing skimmer, vacuum, and filter setups.

Replaces / Cross-Reference Part Numbers

• Intex Adapter B
• Standard 1.25" to 1.5" Pool Hose Adapter

Compatibility & Fitment

• Compatible with Intex, Bestway, and Coleman above-ground swimming pools, skimmers, and filter pump systems.
• Fits standard 1.25-inch (32mm) and 1.5-inch (38mm) diameter corrugated pool vacuum hoses.
• Ideal for adapting newer, high-capacity 1.5-inch sand filter pumps or saltwater generators to pools equipped with standard 1.25-inch wall fittings.

When to Replace

• Existing plastic adapters are cracked, brittle, or completely shattered due to prolonged UV sun exposure and chemical degradation.
• Air is actively leaking into the suction line at the connection point, causing the filter pump to lose prime or cavitate.
• Water continuously drips or sprays from the hose junction when the pump is operating under pressure.
• The original metal clamps are rusted tight, stripped out, or fail to apply sufficient mechanical clamping force.

Installation Tips

• Turn off the pool filter pump and plug the interior pool wall fittings (or lift the hoses above the water line) to prevent drainage during installation.
• Slide the loosened stainless steel clamp over the bare hose end before pushing the hose onto the rubber adapter fitting.
• Push the hose firmly over the ribbed section of the adapter to ensure maximum surface area contact and seal integrity.
• Position the hose clamp directly over the thickest part of the connector barbs and tighten firmly with a nut driver or flathead screwdriver; avoid overtightening which can warp the internal plastic flow pipe.