SKU: 66666321852

Mitsubishi Challenger engine ECU / ECM control module repair service by post

$112.05 $124.50
Save 10%
No.2 Bestseller on salfueradeti.es >

Pay in installments of $31.12 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Aug 9 - Aug 14

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Mitsubishi Challenger engine ECU / ECM control module repair service by postPLEASE NOTE THIS IS A REPAIR SERVICE AND NOT A PHYSICAL PRODUCT !!!! This is not a replacement ! It is a repair service on your existing ECU unit. The repair price of 249 is just an average cost. So please enquire for an exact quote before sending in. Your ecu will be tested by a technician with many years of experience. If your ECU is tested and no faults are found there will be a small test fee instead of the repair cost. We must have your vehicle

PLEASE NOTE THIS IS A REPAIR SERVICE AND NOT A PHYSICAL PRODUCT !!!!

This is not a replacement !

It is a repair service on your existing ECU unit.

The repair price of £249 is just an average cost. So please enquire for an exact quote before sending in.

Your ecu will be tested by a technician with many years of experience.

If your ECU is tested and no faults are found there will be a small test fee instead of the repair cost.

We must have your vehicle fault description and any fault codes to test for the particular fault you have.

Contact us first with your ECU part number or a picture of your ecu label for an instant quote. 

Contact information is in the business seller section below.

Once your ecu is repaired it does not need programming it will be just simple plug & plug

Please DO NOT click buy it now until the job is complete.

Some repairs take longer than others depending on the extent of the damage (ie water ingress or rare components).

There are many types of ecu some are harder to test than others depending on the fault description so please bare with us.

If in the unlikely event that your unit is beyond economical repair. You will be contacted and we will try our best to find a solution for you ie finding a replacement for you.

I TEST & REPAIR 90% OF ALL ECU'S ANY MAKE & MODEL PLEASE ASK.
















Other part numbers that can be looked at are;

0281010437  MR577268

0281010438  8200066001

0281011610  8200319971

0281012535

0281012617  1860A6

0281014108  1860A9 06

MD119323

MD120208

MD128621

MD136476

MD141146

MD152981

MD153986

MD158963

MD159961  E2T35673

MD159963

MD159964

MD161183

MD162164

MD162165  E2T37472

MD162603

MD163154

MD164453

MD166253

MD166265

MD166267

MD167736

MD167737

MD168735

MD172611

MD174845  E2T37680

MD175514

MD175667  E2T38974

MD175668

MD175915

MD176817

MD176818

MD177138

MD182412

MD184831

MD186312  E2T35680

MD187701

MD189410

MD189411

MD189748  E2T39371

MD192684

MD197758  E2T39971

MD197761

MD199025

MD305409

MD305411

MD305571

MD305771

MD306934

MD310342

MD310343  E2T61475

MD311121

MD311682

MD311683  E2T39978

MD312459

MD312468  E2T38387

MD313046

MD322386

MD322387

MD323551

MD325866

MD329097

MD329098

MD330704

MD333184

MD334794

MD336304

MD339958

MD340285

MD341150

MD355427

MD359134

MD362347

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 66666321852

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.1 ★★★★★
Based on 12 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
J
Verified Purchase
JBDoge
Massapequa, US
★★★★★ 5
Wish they came with instructions...
They are cheap and work great. They plug right into my Pioneer vsx521 receiver and my Paradigm Atom monitor speakers. I wish they came with instructions, because it took me about 10 minutes to realize the bottom part unscrews in addition to the top part. Here are my instructions for installation: 1) Unscrew the bottom part of this connector (the thin metal underneath the red/black ring). 2) Make sure the Banana Plug (which may be loosely screwed into the top part of the connector) is fully tightened down 3) Strip your wire tips to 3/8 of an inch (or just slightly under) 4) Run the first newly stripped wire end through the bottom part you removed in step 1, such that the stripped end of the wire is entering through the flat end and exiting through the smaller threaded end. 5) Leave about 1/8 to 3/16 of an inch of stripped wire hanging past the exit hole. 6) As evenly spaced as possible, bend the over-hanging wire strands over the exit hole (all around it, like a hat). If done properly, the wire should not fall out if you give it a VERY GENTLE tug. 7) Screw the top metal part (with the actual banana plug) back onto the bottom part. It may be difficult if your stripped wire is hanging too low. I've used a pair of pliers to grip the bottom part of the connector while I twist the banana plug side with my hand. If done correctly, you should be able to put a lot of tension between the wire and connector without removing/damaging it. UPDATE: I just recently helped my dad install his 5.1 system without these... it sucked... This item (5 pairs of them in this case) and a good wire stripper can save you alot of pain (both physical and mental). The connectors on the back of his receiver are the kind where bare wire comes in from the side and then the connectors screw down (with a banana plug hole in the center which is where this product would come into play). I felt like a surgeon trying to get a bare wire end into the little slot, and then holding it there while I tighten the connector which is almost impossible since they are so close together... GET THESE!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 8, 2012
R
Verified Purchase
R. Jackson
West Palm Beach, US
★★★★★ 1
'Monoprice' = Worst stereo banana plugs on T-H-E market.
Size: 5 Pack, Pattern Name: Banana Plugs
The absolute WORST in stereo banana plugs - HANDS DOWN. After installing stereos and components for over 30 years, I'd say I'm experienced. These banana plugs fail at EVERY part of the design. Allow me to explain... 1) Starting with the tips, they are loose off the bat and fit LOOSELY in either the stereo input studs or speaker input studs by their 'girth'. They do not firmly seat in any plug and for this setup, I'm using a nearly $2K setup all together. They 'rock' back and forth (when inserted) and thus create a non-permanent connection, again, seriously making these utter junk. I've seen some items you can get by with over the years, but these aren't even rock bottom. They are unusable! 2) Next, the banana plugs themselves comes as three pieces. No non loosening o-ring seal but a plastic colored want-to-be imitation for positive and negative notation. Why do these stupid things come in three pieces? - I simply can't tell you why. I do know they serve no specific piece to solving the puzzle of installation so why do they come in three pieces...? My speculation is they are cheap china knockoffs. 3) The 'way' in which you normally install the trimmed wiring internally with the 'two-piece' design permits you to firmly CRIMP and hold the unsheathed wiring; but these do not. The overlap/overlay of the exposed wiring can only be about 2/16's of an inch thus not much to create a proper connection with. This single fact eliminates these plugs as even worthwhile component add ons; period. If you can't achieve a good ground/wiring connection, these are a defeated purpose... 4) Because of the design of these, they have no room to crimp and screw on the cable so your forced to nearly break your fingers in an attempt to get the unsheathed wire to overlay the internal threading and twist them on with all your might. This in effect breaks nearly every wire thread internally and then they breaks off inside. Absolute garbage. These are total pieces of non-quality junk that did nothing but makes me waste 30 minutes on attempting to get them securely on and another 25 to locate my Amazon account, find this product in my order and ALARM anyone else from making the same mistake I made. Now, I find out I can't even get a return on these. Thanks Amazon. Thank you third party retailer. You just made me a very dissatisfied decade long customer.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 17, 2016
A
Verified Purchase
Amazon Customer
Lake Worth, US
★★★★★ 5
Nice quality
Had to return due to our mistake but the mechanic said it was good quality. Ordered the correct size and worked great.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 30, 2025
K
Verified Purchase
katelyn traut
Boise, US
★★★★★ 5
Perfect fit
Worked great for a 1965 mercury thunderbolt 150hp
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 3, 2025
L
Verified Purchase
Lawrence Brown
Lake Worth, US
★★★★★ 5
MerCruiser Replacement Parts
OEM quality MerCruiser Alpha 1 Gen1 replacement part. Everything you need and some things you don't because it's a universal kit that works for several models.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 19, 2025

recommand products

Dennis Brown - Love Is So True
29.99
Ty Beanie Baby - Spuds the Dog (8 in)
14.00
Mark Farner - Rock 'n Roll Soul: Live, August 20, 1989
25.99
Javier Perianes - Granados: Goyescas - El pelele
27.99
Ty Beanie Baby - Hippity The White Easter Bunny (9in)
19.00