Pay in installments of $46.12 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 27 - Aug 1
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Kidde Firex 3x KF20R Optical Smoke & 1x KF30R Heat Alarm Kit Mains Powered with Sealed-In Rechargeable Battery Back-UpKidde Firex 3x KF20R Optical Smoke & 1x KF30R Heat Alarm Kit Mains Powered with Sealed In Rechargeable Battery Back Up FULLY COMPLY WITH THE NEW 2022 SCOTTISH & WELSH REGULATIONS 3x Mains Powered Optical Smoke Alarm (KF20R): Mains Optical Smoke Alarm Features: Mains powered optical smoke alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat. Once interlinked, the detection of the relevant danger by
Kidde Firex 3x KF20R Optical Smoke & 1x KF30R Heat Alarm Kit Mains Powered with Sealed-In Rechargeable Battery Back-Up
FULLY COMPLY WITH THE NEW 2022 SCOTTISH & WELSH REGULATIONS
3x Mains Powered Optical Smoke Alarm (KF20R):
Mains Optical Smoke Alarm Features:
Mains-powered optical smoke alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat.
Once interlinked, the detection of the relevant danger by an individual unit will sound across all the connected alarms.
Optical alarms are for use in escape or circulation routes and in areas where there is a danger of ignition of furniture and surroundings by cigarettes producing slow, smouldering fires.
This mains-powered unit should be installed by a qualified electrician and can be used throughout the home, except in the kitchen where a Firex Heat Alarm is recommended. These alarms comply with UK Building Regulations for new housing and associated standards (Grade D BS 5839, Part 6).
- Interlink with up to 23 Firex hard-wired alarms – all alarms sound if danger is detected
- Alarm memory – identifies source unit within interconnecting network
- Combined Test/Hush button allows regular testing of alarm function and can be used to temporarily silence nuisance alarms
- Auto reset after activation
- Tamper-resistant locking device – prevents unauthorised removal without the use of a tool
- Mains operation – Built-in rechargeable Lithium back-up tamper-proof battery
Mains Optical Smoke Alarm Specification:
- Model KF20R
- Power Supply 230V mains-powered with built in rechargeable lithium battery back up
- Temperature Range 0ºC to + 40ºC
- Humidity Range Up to 93% Relative Humidity (RH) non-condensing
- Storage and Transport -20ºC to +60ºC and 5–95% relative humidity (RH) non-condensing
- Alarm Dimensions 127 x 127 x 39mm
- Bracket Dimensions 133 x 133 x 6mm
- Alarm Weight 242g
- Warranty 6 years
- Approvals BSI certified to BS EN14604:2005
- CE tested and certified Sensor Optical, circular lateral chamber with insect-resistant width slot entry portals and added bug screen mesh
- Chamber Size 35mm outside diameter x 16mm depth approximate (external)
- Detection Band Infrared light wavelength
- Button Test Simulates the effect of smoke within the sensing chamber, checks electronics and sounder
- Automatic Self-test Circuitry is tested and unit beeps (chirps) if fault is detected
- Supply Voltage 230V AC, 50 Hz (nominal UK voltage)
- Power Consumption < 15mA
- Connection Push-in/snap-fit type connector with 150mm long flying leads (supplied)
- Battery Back-up User-replaceable alkaline 9V battery (522/6LR61)
- Power-on Indicator Continuous green LED
- Alarm Sounder Electronic piezo-electric sounder (T3 pattern sound - 3 pulses - space - 3 pulses), soldered contacts
- Sound Output 85dB (A) minimum at 3 metres
- Alarm Frequency 3.2 kHz typical
- Dust Protection In-built foam gasket in rear of alarm to prevent dust ingress into rear of the alarm
- Alarm Status Red LED flashes approx once every five minutes = normal operation
- Red LED flashes once a second = sensing smoke (sounder alarm sounds)
- Red LED flashes once every ten seconds = in hush condition (auto-reset after 15 minutes)
- Interconnection Up to 24 Firex and Kidde ‘Slick’ units (smoke, heat and CO) can be hardwire interconnected with optional control (see below)
- Optional Controls Wired Remote Test and Hush Unit (REMTH) allows test and hush of interlinked units
- Optional Pattresses SMK23RU also has integral switchable relay for operating remote devices
- SMK4896 – Surface mounting base for added ease of installation
- Fixing Mounting bracket ring supplied with two ‘T’ slot fitting option
- 57mm spacing to a maximum of 90mm for standard screw fittings on back boxes
- Bracket has 50mm diameter central access hole for cabling
- Plastics used NORYL – Cover, main body and mounting bracket
- Lead-Free Status All Firex alarms are lead-free
1x Mains Powered Heat Alarm (KF30R):
Mains Heat Alarm Features:
Mains-powered heat alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat.
Once interlinked, the detection of the relevant danger by an individual unit will sound across all the connected alarms.
Mains-powered heat alarms can be used throughout the home in humid or dusty environments where an optical or ionisation smoke alarm is unsuitable, e.g. kitchens, loft spaces and garages.
The Firex range requires installation by a professionally qualified electrician and complies with UK Building Regulations for new housing and associated standards (Grade D BS 5839, Part 6).
- Interlink with up to 23 Firex hard-wired alarms – all alarms sound if danger is detected
- Alarm memory – identifies source unit within interconnecting network
- Combined Test/Hush button allows regular testing of alarm function and can be used to temporarily silence nuisance alarms
- Auto reset after activation
- Tamper-resistant locking device – prevents unauthorised removal without the use of a tool
- Mains operation – Built-in rechargeable Lithium back-up tamper-proof battery
Mains Heat Alarm Specification:
- Model KF30R
- Power Supply 230V mains-powered with rechargeable Lithium battery back-up
- Temperature Range 0ºC to + 40ºC
- Humidity Range Up to 93% Relative Humidity (RH) non-condensing
- Storage and Transport -20ºC to +60ºC and 5–95% relative humidity (RH) non-condensing
- Alarm Dimensions 127 x 127 x 39mm (not including heat sensor guard)
- Bracket Dimensions 133 x 133 x 6mm
- Alarm Weight 180g
- Warranty 6 years (including battery)
- Approvals BSI certified to BS5446 Part 2: 2003
- CE tested and certified
- Sensor Thermistor (Thermal Resistor) within detection unit
- Button Test Simulates the effect of heat at the sensor, checks electronics and sounder
- Automatic Self-test Circuitry is tested and unit beeps (chirps) if fault is detected
- Supply Voltage 230V AC, 50 Hz (nominal UK voltage)
- Power Consumption < 15mA
- Connection Push-in/snap-fit type connector with 150mm long flying leads (supplied)
- Battery Back-up Non user-replaceable 3 x 3V rechargeable Lithium Aluminium Alloy / Magnesium Composite
- Oxide cells (ML2430)
- Power-on Indicator Continuous green LED
- Alarm Sounder Electronic piezo-electric sounder (T3 pattern sound - three pulses - space - three pulses) with soldered contacts
- Sound Output 85dB (A) minimum at 3 metres
- Alarm Frequency 3.2 kHz typical
- Alarm Status Red LED flashes approx once every five minutes = normal operation
- Red LED flashes once a second = sensing heat in excess of 58ºC (sounder alarm sounds)
- Interconnection Up to 24 Firex and Kidde ‘Slick’ units (smoke, heat and CO) can be hardwire interconnected with optional control (see below)
- Optional Controls Wired Remote Test and Hush Unit (REMTH) allows test and hush of interlinked units
- Optional Pattresses SMK23RU also has integral switchable relay for operating remote devices
- SMK4896 – Surface mounting base for added ease of installation
- Fixing Mounting bracket ring supplied with two ‘T’ slot fitting option
- 57mm spacing to a maximum of 90mm for standard screw fittings on back boxes
- Bracket has 50mm diameter central access hole for cabling
- Plastics used NORYL – Cover, main body and mounting bracket
- Lead-Free Status All Firex alarms are lead-free
Please note: Alarms are sold individually.
Data Sheet:
Data Sheet for KF20RData Sheet for KF30R
Instruction Manual:
Instruction Manual for KF20RInstruction Manual for KF30R
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.7 ★★★★★
Based on 23 reviews
Sort
Product Reviews
★★★★★ 5
Great Mint Flavor, better mouth profile
Size: 60 Count (Pack of 1)
Unlike others, I prefer these to the Zylimelts. I like the fact that the flavor is stronger and it's a good mint flavor. it has a little bit of a zing to it but it hasn't hurt my mouth. I find that these give me a better mouth feel than either Zylimelts or the Rite Aid brand which is what I was using before. I chose Rite Aid over Zylimelts because they had a better flavor and mouthfeel and were less expensive the Zylimelts, which left a scummy film in my mouth. Zylimelts are bit larger too & they hurt my mouth from their hard edges & size. Zylimelts leave a yucky coating in my mouth but didn't moisturize anywhere near as well as either Rite Aid or these Freshmelts. These have a lower height & more rounded edges so they don't hurt as much as the others. Fresh melts are also less expensive than the other two. Mostly Zylimelts had difficulty melting because they just don't moisturize well. Even my 99 year old Mom preferred Rite Aid over Zylimelt. Sadly she passed away before I discovered these wonderful FreshMelts.
Personally I would suggest if this flavor is too strong for you, see if they come in another flavor, or try the Rite Aid brand of Zylimelts, called "oral care dry mouth discs" in mint flavor also available here on Amazon. They don't have as rounded a top edge as OraCoat's 2 products but they definitely moisturize better than Zylimelts, in my opinion & I think they come in another flavor too. FreshMelts definitely have the most mit flavor, thanks to the mint oil in them, which is what irritates some people. I haven't had that issue & prefer the tingle & freshness, which makes these much better for daytime use as well & lasts longer than Pur mints or Therabreath's dry mouth lozenges (tho sensitive mouths avoid their mandarin mint, it's extremely zingy, maybe even acidic, at least even I only use if out of everything else because of how strong the zing is - which is probably why they were so much cheaper than other flavors. Ha ha. Time before I got another flavor & while tingly, wasn't bad. For Nighttime however, nothing beats the adhesive disc melts. I vote Freshmelts best for good strong flavor, best comfort/size profile & also cheapest, always a plus for me!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 8, 2022
★★★★★ 5
Handy to keep in your pocket for refreshing mouth
Size: 160 Count (Pack of 1)
Oracoat FreshMelt Stick-on are great if you have dry mouth. I use them when I go to church and they stick to the roof of my mouth and stay in place for close to 2 hrs. I have also used them at night when I wake up and can't seem to get my mouth refreshed with water.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 30, 2026
★★★★★ 4
The best, but also the most expensive
Size: 160 Count (Pack of 1)
These are the best dry mouth tabs I’ve found. They actually stick-on and last for hours. I struggle so much with dry mouth when I sleep and these have been the longest lasting. They are pretty expensive, which is why I gave them 4* instead of 5, but I haven’t found any that work better.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 4, 2026
★★★★★ 1
Huge Disappointment & Waste of $17.09
Size: 160 Count (Pack of 1)
I have been using "OraCoat XyliMelts Dry Mouth Relief Oral Adhering Discs Slightly Sweet with Xylitol" everynight for years. They work like a charm and I wake up feeling fresh and ready for the day. When I saw "Oracoat® FreshMelts® Fresh Breath Stick-on™ Melts" I was super excited. I was hoping they would be a little more minty and similiar to the XyliMelts, but saddly they are not. The Freshmelts do not have a good taste, something was just off with the flavor (chemical?). They did not help moisten my mouth like XyliMelts do. Adhering well is honestly the is only positive thing. Because the XyliMelts have been such an amazing product, I purchased the 160 count for $17.09 and I am unable to return them. I really expected more from Oracoat. I would NOT recommend this product.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 27, 2023
★★★★★ 5
Good
Size: 40 Count (Pack of 1)
Refreshing
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 23, 2026