JL Audio XDM400/4 : 4ch x 75W/100W Marine Grade Amplifier @ 4Ω/2Ω

JL Audio XDM400/4 : 4ch x 75W/100W Marine Grade Amplifier @ 4Ω/2ΩXDM Series Four Channel Class D Marine Grade Amplifier, 100 Watts x Four Channels @ 2 Ohm or 75 Watts x 4 Channels @ Four Ohm. The ultra compact XDM400 4 packs a serious full range punch, generating a whopping 100 watts to each of its four channels into 2 ohms (14. 4V, 1% THD). The technology that makes this much power possible in such a compact chassis is our advanced NexD high speed switching design, which permits full bandwidth Class D operation

XDM-Series Four-Channel Class-D Marine-Grade Amplifier, 100-Watts x Four-Channels @ 2-Ohm or 75-Watts x 4-Channels @ Four-Ohm.

The ultra-compact XDM400/4 packs a serious full-range punch, generating a whopping 100-watts to each of its four channels into 2-ohms (14.4V, 1% THD). The technology that makes this much power possible in such a compact chassis is our advanced NexD high-speed switching design, which permits full bandwidth Class-D operation with extremely low distortion and remarkable efficiency.

Suitable for car or boat installations, the XDM400/4 is built with marine-grade materials and features an exclusive, dual-mode input filter for noise-free performance in boats or cars. Automatic turn-on capability (via signal sensing or DC-offset sensing) is also onboard for easy factory system upgrades.

Combine the XDM400/4 with our XDM600/1 monoblock to build a stunning 1000W amplification system to power four satellites and a subwoofer... and fit the whole thing under a seat or deck. Or, use the XDM400/4 by itself to power two satellites, plus a subwoofer. 

The XDM400/4 includes a 12dB / octave filter for each channel bank, which can be configured as a low-pass or high-pass filter and offers continuously variable cutoff frequency selection from 50-500Hz. With the addition of an optional HD-RLC or MHD-RLC (water-resistant) remote level controller (each sold separately), you have the ability to adjust the level of all amplifier channels or just the rear channels directly from the driver's seat or cockpit.

Finished in a sleek, black powder-coat, all controls are protected beneath a gasketed, removable top cover for easy access.

Output Specifications

• @ 4 Ω	75 W RMS x 4 @ 14.4V
  @ 2 Ω	100 W RMS x 4 @ 14.4V
  Bridged @ 4Ω	200 W RMS x 2 @ 14.4V

• @ 4 Ω	60 W RMS x 4 @ 12.5V
  @ 2 Ω	90 W RMS x 4 @ 12.5V
  Bridged @ 4Ω	180 W RMS x 2 @ 12.5V

General Specifications

• Frequency Response	12 Hz - 22 kHz (+0, -1dB)
  S/N Ratio, referred to highest rated power	>104 dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth)
  S/N Ratio, referred to 1 W	>84 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)
  Damping Factor @ 4 Ω	>150 / 50 Hz
  Damping Factor @ 2 Ω	>75 / 50 Hz
  THD+N @ Rated Power	<1% @ 2 Ω per Ch.
  Input Voltage Range @ RCA Inputs	200 mV - 4 V RMS
  Min.Copper Power / Ground Wire Gauge	4 AWG wire
  Fuse Rating	40 A (AFS, AGU or MaxiFuse™)

Amplifier Settings

• Filter Mode(s)	Low-Pass or High-Pass
  Filter Slope(s)	12 dB/octave
  Filter Frequency Range	50 Hz - 500 Hz
  Detented, Calibrated Filter Freq. Potentiometers	Yes
  Filter Defeat Function	Yes
  Remote Level Control	Optional HD-RLC or MHD-RLC (water-resistant)
  Remote Level Modes	2 or All channels
  Channel Input Mode Switch	Yes (2/4 ch.)
  Pass-Through Preamp Output	Buffered
  Source Channel Selection for PreOuts	Yes

Documentation

• JL Audio XDM400/4v2 Manual