Pay in installments of $965.83 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 25 - Jul 30
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
2011-2016 Superduty 4" FOX 2.5 Performance Elite Conversion Kit (BDS1597FPE)Upgrade your 2011 2016 Ford F250 F350 Super Duty diesel with this BDS 4" radius arm lift kit and FOX 2. 5 Performance Elite coil over conversion, clearing up to 35" tires. Up front it includes diesel specific FOX 2. 5 coil over shocks, heavy duty replacement tubular radius arms, forged drop pitman arm and track bar bracket for steering correction, sway bar relocation and brake line brackets. The rear uses a high strength fabricated lift block, a u
Upgrade your 2011-2016 Ford F250/F350 Super Duty diesel with this BDS 4" radius arm lift kit and FOX 2.5 Performance Elite coil-over conversion, clearing up to 35" tires. Up front it includes diesel-specific FOX 2.5 coil-over shocks, heavy-duty replacement tubular radius arms, forged drop pitman arm and track bar bracket for steering correction, sway bar relocation and brake line brackets. The rear uses a high-strength fabricated lift block, a u-bolt flip kit for max ground clearance, brake line brackets and a matching set of FOX Performance shocks.
The FOX 2.5 Performance Elite shocks add a remote reservoir for extra fluid capacity and cooling, with Dual Speed Compression Adjusters offering 10 low-speed and 12 high-speed settings.
Features
- FOX 2.5 coil-over mounts in the factory coil bucket location
- Secondary FOX 2.0 shock added for max performance
- Dual Speed Compression Adjust: 10 low-speed and 12 high-speed compression settings via twist knobs
- Black anodized aluminum reservoir to increase cooling efficiency
- Heavy duty tubular steel radius arms correct caster while maximizing ground clearance
- Track bar relocation bracket and drop pitman arm maintain proper steering angles
- U-bolt flip kit for maximum ground clearance
- FOX shocks fully serviceable and resistant to corrosion and harsh environments
Specs
- Front Lift Method: Coil-Over
- Rear Lift Method: Block
- Shocks Included: Yes
- Front Lift Height: 4 inch
- Rear Lift Height: 2 inch
Recommended Tire & Wheel Fitment
- Tire Size: 35x12.5
- Wheel Diameter: 20x9
- Back Spacing: 4.5
Notes
- Removal of factory block required. Rear add-a-leaf required for models with factory 3-7/8" block for a level to tail high stance. Single add-a-leaf kit 113218 recommended for a more level stance; dual add-a-leaf kit #113209 for tail high. (Add-a-leafs do not apply to rear leaf spring-equipped systems.)
- If equipped with a 2-piece driveshaft, a driveshaft alignment kit (#123402) may be required.
- Although extremely rare, front and/or rear driveline vibration may occur.
- If equipped with a rear sway bar, #123009 is required.
- U-bolts will not work on dually.
Includes
- BDS003629, Ford F250/350 6 Inch Rear Spring (UPC 658848611393)
- BDS013409, 2011-2016 Ford F250/350 Rear Box Kit (UPC 658848613410)
- BDS013424, 2011-2016 Ford F250/F350 4 inch Radius Arm Front Box Kit (UPC 658848613502)
- BDS123212, 2005-2016 Ford F250/F350 Super Duty Coilover Mount Kit (2 inch-8 inch) (UPC 711745604063)
- BDS123251, 2005-2022 Ford F250/F350 Radius Arm Kit, Pair (UPC 711745604087)
- FOX88406427, Kit: BDS 2005-On Ford SD Front Coilover, 2.5 Truck Fox Performance Elite Series, R/R 4 inch Lift, Dual Speed Compression Adjust
- FOX98224700, Fox 2.0 Shock 25.65 x 16.05 x 2- S50/EB1
- FOX98224760, Fox 2.0 Shock 33.85 x 20.75 x 2- EB1/EB1
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.3 ★★★★★
Based on 16 reviews
Sort
Product Reviews
★★★★★ 5
Game changer
Size: Width 14", Adjustable Desk Mount, Style: Dual, Size: Width 14", Adjustable Desk Mount, Style: Dual
**update 2026**
Okay I've just upgraded this mount so let me update my review. I am keeping 5 stars because for an entry level budget mount it did its job.
Here's why I changed: if your desk is not solid wood, the base of the mount is too narrow and will start to sink in. Also, after a few years one of the arm started to sag. I upgraded for a mount double this price so not outrageous but the base is wider and the arms are sturdier. I am still happy I purchased that one because for my budget it did the job so these years and it's better than not having it. Still recommend if your budget is low and you need to save desk space, it's a great starter. If you can wait and save twice this, I suggest you do and skip to the better ones though.
**original review 2020**
Been using this mount for about 3 months, time to review:
It is an absolute game changer! Cheap, easy to assemble and install, feels sturdy. At first my wife was skeptical because she thought it would be a gimmick but it frees up so much space, it brings both monitors to the same eye-level height, the mouse cable never gets stuck under the laptop anymore, and it holds the cables in place so that when she has to run with the laptop they don't fall behind the desk anymore (see picture). All these little details improved her productivity. And just visually it looks much better I think. Laptop: 15" Monitor: 24"
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 9, 2020
★★★★★ 3
Works fine overall, but... "you get what you pay for"
Size: Width 16.5", Fully Adjustable Desk Mount, Style: Single
Filed under: "you get what you pay for"? I like the price point and FOR THE MOST PART this arm is getting the job done in my home office space *but* a few points...
(1) The little "claw" to hold the laptop in place has these little "locks" that are on the under side which... that's OK but they can be hard to see and it just seems like an extra part that can break -- vs. a ratcheting clamp.
(2) The tension on every movable part was ALL out of whack when I first installed it. I set the laptop onto the cradle and it basically collapsed -- flipping down as far as it would go. I had to adjust the tension to be significantly higher in order to hold steady -- but NOW it's hard to "fine-tune" because the tension on that joint is so stiff. On the other hand, the main "elbow" joint is easy to adjust *and* holds steady all day, but within seconds of taking my laptop off of the arm, it springs up -- sometimes rather violently.
(3) The overall build quality seems a little weak. The main screw to hold the laptop stand in place had a little cap to make it easier to twist it by hand -- but this snapped off during the initial installation. Not a deal-breaker because once it was in place, I didn't expect to move it again BUT it was still disappointing.
(4) Not a deal-breaker for me BUT... there's practically no included cable management. Just... be aware of that.
Otherwise... instructions were pretty clear vis-à-vis how to install and -- like I said -- it seems to be getting the job done w/r/t/ getting the laptop up off the desk and MOSTLY aligned with my other monitors.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 23, 2025
★★★★★ 5
Superb quality. Couldn't be happier.
Size: Width 14", Adjustable Desk Mount, Style: Dual
I have been looking for a separate monitor and laptop stand for a while now and recently came across this set up from WALI. For under $50, I was a little nervous about the quality before it arrived. I had no reason to be concerned. It is a SOLID set up. Everything is high-quality metal construction and secure when assembled. Set up took some doing but only because I am not the most, um, detailed direction follower...Make sure you tighten the tray and post screws TIGHTLY initially to prevent any kind of movement after you've assembled it (don't ask me how I know).
I have a 15'' Asus laptop and the lip on the tray holds it fine as long as I don't tip it too far forward. But it's an unusually thick laptop body so I imagine most won't have an issue. Again, it's not a problem for me at all, just limits slightly the angle I can tilt the tray.
If you are ok with the configuration shown in the primary product image (i.e., monitor above tray) then it will be no problem as is. My desk isn't that deep so I had wanted them to be side-by-side. I was able to set it up that way out of the box. But my monitor was just a hair too big and it cast a shadow on the laptop monitor in the side by side configuration. Support was kind enough to send me a second base post and screws so I could use the grommet and clamp bases at the same time (as is you can only use one or the other). This of course only works if you already have a hole in the desk (or are willing to put one in yourself). Many thanks to WALI's support crew for accommodating me.
I use a standing desk. If movement while you type is something you're fussy about (I'm not) note there will be some shake, especially in the standing position. But for most, it should be absolutely no problem.
Overall a fantastic deal. Highly recommend it!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 18, 2018
★★★★★ 5
A Powerhouse USB Hub That Handles Everything I Throw at It
Color: Gray
I’ve been using this 17‑Port 96W Powered USB 3.2 Hub for a few weeks now, and it has completely streamlined my workspace. With 10 USB‑A 3.2 ports, 2 USB‑C 3.2 ports, 3 QC 24W fast‑charging ports, and an SD/TF card reader, this hub truly replaces multiple adapters and dongles. The 10Gbps transfer speeds are legit — large files from my SSDs move quickly and consistently without random disconnects.
The 96W power supply is a huge plus. Even with multiple external drives, peripherals, and a webcam connected, everything stays stable. No flickering, no dropouts, no “device not recognized” issues. The individual power switches are surprisingly useful too — I can turn off specific drives without unplugging anything.
The build quality feels solid and premium. It doesn’t slide around, and it stays cool even under heavy load. The SD/TF card reader is fast and convenient for photo/video work. The QC fast‑charging ports are also great for topping up my phone or accessories, though they’re charging‑only (no data), which is clearly stated.
If you’re someone who uses multiple devices — external HDDs, flash drives, cameras, microphones, card readers, etc. — this hub is a game changer. It’s perfect for PC setups, content creators, IT workstations, and anyone who needs serious connectivity.
Overall, this is one of the most capable, stable, and well‑designed USB hubs I’ve used. Absolutely worth it.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 4, 2026
★★★★★ 5
Need lots of connectivity + charging. EXCELLENT.
Color: Gray
Problems with my original USB hub required something better. This unit has allowed me to connect all my peripherals to my laptop and I haven't had any problems with the USB port reliability I was dealing with. I'm using two hubs in series and now everything is working perfectly.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 25, 2026
recommand products
Robert Wynne Glass ~ Apple (Colbalt)
130.00
Guest 2101 Battery Switch 4 Pos W/o Field Disconnect
55.99
Razer Kiyo Pro USB Camera with High Performance Adaptive Light Sensor
3735.00
Newmar Ss Switch 15 Transfer Switch 15kw 023-2202-0
212.00
Nintendo Switch Hotel Transylvania Scary Tale Adventures (EU)
825.00