Bass neck - replacement neck for J Bass - rosewood fingerboard - no finish - left-handed

Bass neck - replacement neck for J Bass - rosewood fingerboard - no finish - left-handed20 frets Maple bass neck, sanded, unfinished and ready to spray Rosewood fingerboard with white inlay dots 10 (25. 4mm) radius Nut width 1 1 2 (38. 1mm) Heel width 2 7 16 (62mm) Tuning peg hole diameter 11 16 (17. 5mm) Truss Rod adjustment at heel Neck thickness . 89 (22. 6mm) at first fret, 1. 01 (25. 7mm) at twelfth fret Unless otherwise noted, all necks are made of the highest quality wood in either the United States or Japan. No two necks are

• 20 frets
• Maple bass neck, sanded, unfinished and ready to spray
• Rosewood fingerboard with white inlay dots
• 10” (25.4mm) radius
• Nut width 1-1/2” (38.1mm)
• Heel width 2-7/16” (62mm)
• Tuning peg hole diameter 11/16” (17.5mm)
• Truss Rod adjustment at heel
• Neck thickness .89“ (22.6mm) at first fret, 1.01“ (25.7mm) at twelfth fret

Unless otherwise noted, all necks are made of the highest quality wood in either the United States or Japan. No two necks are exactly the same and may differ slightly from what is pictured. All necks have a Limited Warranty against defects in materials and workmanship. Warranty does not cover normal fret wear or customer modifications. Unless otherwise noted, this neck is licensed to Allparts Music Corporation by Fender^® Musical Instruments under a quality control trademark license. Allparts Music Corporation is not affiliated with Fender^® and no Fender^® warranty applies.

All necks may require fret leveling and polish, and may need to be fine tune to fit your instrument. This is normal and not a defect. All necks should be carefully inspected prior to installation and/or modification. All wood is unique with individual growth patters. Allparts cannot warranty a neck that does not get a sealer/finish put on it, as humidity, sweat, and temperature can cause the neck to warp and twist.