3-Point Westcoast Saw Felling Dogs

3-Point Westcoast Saw Felling DogsThese 3 point felling dogs (bumper spikes) are made from proprietary ultra high strength steel. With a longer center dog that lines up with the chain kerf, this design offers better articulation and a smoother, more effortless cut. Made in the USA. Included: All Stihl, Husqvarna, Makita, and Echo dual felling dog models include a chain catcher. Felling dogs are sold as a set OR as a single inside spike, which is dependent upon the specific saw model.

These 3-point felling dogs (bumper spikes) are made from proprietary ultra-high strength steel. With a longer center dog that lines up with the chain kerf, this design offers better articulation and a smoother, more effortless cut. Made in the USA.

Included: All Stihl®, Husqvarna®, Makita®, and Echo® dual-felling dog models include a chain catcher. 

Felling dogs are sold as a set OR as a single inside spike, which is dependent upon the specific saw model.

Installation Notes:

Clutch Cover - Some clutch covers may not have revision holes pre-drilled from the factory. This may require you to drill through your cover to attach the outside dog. Look on the inside of your cover for hex-shaped indentions. That's where you will drill. We recommend ordering our extra-long hardware kit for this application.

Warranty - You must run a Stihl® chain roller on any dual felling dog setup to add additional strength and support. Without running a chain roller on these felling dogs, the stress may cause the outside dog to fracture. We only guarantee our felling dogs if you run the chain roller. Chain roller for all Stihl® compatible dogs sold separately.

U.S. PATENT NO. D1018234, WESTCOAST SAW, LLC

Ⓓ CANADA DESIGN REG. NO. 209517, WESTCOAST SAW, LLC

Stihl® is a registered trademark of Stihl® Incorporated and is used only to describe their products.