SKU: 21375693755

Victron Centaur Charger 12v/50a

$286.65 $318.50
Save 10%
No.2 Bestseller on salfueradeti.es >

Pay in installments of $79.62 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 25 - Jul 30

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Victron Centaur Charger 12v/50aVoltage: 12V Charge Current: 50A Input Voltage: 90 265V Number of Outputs: 3 Protection Category: IP20 Bluetooth Enabled: No Dimensions: H426 x W239 x D135mm Weight: 5Kg The Centaur range of battery chargers features auto ranging input covering 90 265VAC 50 60Hz input meaning they can be used anywhere in the world. Crucially and unlike many other products that state universal input the Centaur range will maintain full output power within the entire

  • Voltage: 12V
  • Charge Current: 50A
  • Input Voltage: 90-265V
  • Number of Outputs: 3
  • Protection Category: IP20
  • Bluetooth Enabled: No
  • Dimensions: H426 x W239 x D135mm
  • Weight: 5Kg

The Centaur range of battery chargers features auto-ranging input covering 90-265VAC 50/60Hz input meaning they can be used anywhere in the world.

Crucially and unlike many other products that state universal input the Centaur range will maintain full output power within the entire specified range. Other features include fully automatic three stage charge characteristic that ensures batteries are fully charged every time and three isolated charge outputs for multi battery configurations to suit the majority of typical installations.

Features

Quality without compromise

Aluminium epoxy powder coated cases with drip shield and stainless steel fixings withstand the rigors of an adverse environment: heat humidity and salt air. Circuit boards are protected with an acrylic coating for maximum corrosion resistance. Temperature sensors ensure that power components will always operate within specified limits if needed by automatic reduction of output current under extreme environmental conditions.

Universal 90-265V AC input voltage range and also suitable for DC supply (AC-DC and DC-DC operation)

All models will operate without any adjustment needed over a 90 to 265 Volt input voltage range whether 50 Hz or 60 Hz.

The chargers also accept a 90-400 V DC supply.

Three outputs that each can supply the full output current

Three isolated outputs to simultaneously charge 3 battery banks Each output is capable to supply the full rated current.

Three-stage charging with temperature compensation

The Centaur charges at bulk rate until the output has reduced to 70% of the rated Amps at which a 4 hour timer begins. After the timed period the charger switches to float rate. An internal temperature sensor is used to compensate the charge voltage with- 2 mV/ºC ( -; 1 mV/ºF) per cell. A DIP switch is available to select the optimum charge/float voltages for Flooded Lead-acid Gel or AGM batteries

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 21375693755

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.2 ★★★★★
Based on 16 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
B
Verified Purchase
Blair Travis
Belleville, US
★★★★★ 5
Just buy the dang thing!
Style: 68oz｜Modern Styles, Style: 68oz｜Modern Styles
Read no other reviews. Just buy it. It’s inexpensive, easy to use, clean, and makes a great cold brew! I took it on vacation to the beach and one batch lasted me all week! Also saved me $$$. Buy it!!!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 23, 2026
J
Verified Purchase
Joe Gonzalez
West Palm Beach, US
★★★★★ 5
It Does a Great Job!
Style: 51oz｜Straight Styles
This brewer is great for cold brewing loose teas. Is glass and Stainless Steel, so no micro trash. The glass is very delicate so handling needs to be careful. Great product. I bought another one.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 16, 2026
A
Verified Purchase
Adam Rainier
Natrona Heights, US
★★★★★ 5
Makes Fantastic Cold Brew. Thoughtful Design. Slightly Frail, But Approaches Perfection.
Style: 51oz｜Conical Styles
When I looked for a dedicated cold brew pitcher, I had a few conditions. Mainly I wanted to avoid plastic at all costs. I needed a pitcher that would be easy to clean and simple to use, without pointless bells and whistles. Finally, I wanted a pitcher that could fit in my fridge without issue. This pitcher achieves all that and then some. Borosilicate is the same stuff Pyrex used to make its glassware from, a material renowned for its durability especially when exposed to quick temperature shifts. I knew it was overkill, but such material would surely fit the bill. And glass wouldn't affect the flavor of whatever coffee I'd brew in it. The grind holder is made from stainless steel, with a fine mesh that largely prevents sediment from getting into the coffee. It does allow smaller particles to get through, but they settle to the bottom. Overall I can't complain. The grind holder is suspended by a rubber ring which also locks the pitcher's lid in place. This forms a nice little seal that seems to help prevent leaking. Obviously there is no vacuum capability here, but it feels sturdy and like it won't let anything in or out once the grind holder is in. Pouring is easy and accurate. I remove the lid and grind holder, then pour. There's never any spillover nor dripping. The pitcher has a good, well-crafted pouring tip. Brewing with the pitcher takes a bit of practice. First I dump old grinds if necessary, then fill the grind holder roughly 3/4 of the way with cold brew grinds. BEFORE I place the grind holder into the pitcher, I fill the pitcher with water about 2 inches below the max line. After that, I place the grind filter into the pitcher then slowly press down on the grinds to flatten and wet them. Finally, I slowly pour water in to hit the max line, flattening the grounds as I do. While the pitcher has notches to determine how much liquid it holds, I don't find that feature helpful because I only use the pitcher with a grind holder which boosts the liquid. I imagine the notch lines may be more helpful for someone using this as a standard pitcher without the grind holder in place. I've accidentally overfilled this pitcher many times before deciding the best way, in my opinion, to handle it as described above. I've tried placing the grind holder in and then pouring all of the water over the grinds. But because grinds have a tendency to rise and overflow, that method proved messy and ineffective. This is why I add most of the water first, then only add a very small amount of water AFTER putting the grind holder into position just to top it off. So how good is the cold brew? After trying a few different approaches, I now brew mine in the fridge for convenience, letting it steep for about a week to make a nice dark roast concentrate with Bizzy Organic Dark & Bold grounds. The result is stellar, easily better than any coffee place cold brew I've had in the past couple of years. Filled to the max line, a full pitcher lasts me about 2 weeks when I have about an inch of coffee per day. I've found cold brew concentrate to be an extremely economical way to stretch costly grinds while creating the richest flavor and this pitcher is a key part of that. With this approach, I'm a happy customer. One thing I like to do while brewing a new batch of coffee is pouring about 1/3 of the brewed coffee into a tall cup and finishing that while brewing. This method has worked perfectly for me, as I have a new pot of coffee by the time I'm done with the old one. One thing to point out is that the pitcher is fairly big and the glass is relatively thin. And so I have always hand washed all parts of this pitcher, which has proven straightforward enough. While borasilicate and stainless steel should be dishwasher safe, this has become too important a piece of equipment for me to start playing around with. So I'm not the person to say how well it holds up in a dishwasher. My outlook is to treat this pitcher with the care it deserves and to be rewarded with its offerings for as long as possible. Overall the pitcher is an all-star at making the coffee I enjoy, being so simple to use that it becomes easy to take for granted. It is almost a trouble-free piece of kitchen hardware and has already paid for itself through sheer convenience. The quality definitely feels top notch, although the thinness of the glass means it needs to be treated with the care and respect it deserves. I would feel very comfortable recommending this product to almost anyone serious about making a quality cold brew at home.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 29, 2020
L
Verified Purchase
Lance Seidman
Birmingham, US
★★★★★ 4
Better than expected (Updated)!
This is a simple and effective solution to making a good cold brew. Too bad the process takes forever (no fault to the product). BUT if you want a stronger taste, after using purified cold water (try to get beans wet), let it sit out for 12 hours or longer but then place in the fridge and you'll notice it darker and richer. It is impossible if you think some ground beans won't end up in your coffee, they will BUT when you pour, as long as you leave the metal ring in, a little bit of coffee (water) and the beans usually get stuck and don't come out. If you're really nuts about it, you can use a cheese cloth but a bit of grounds won't hurt you and not sure you'd really taste it as it's so fine, barely noticeable. Those who keep braking the glass? You must use cold water if you immediately start cleaning the pot. Do NOT run under hot water while the pot is cold, you or course will shatter the glass at some point. Update (07/29/2020) I am still using this product and no issues with it. But it does leave the coffee grounds smell to it no matter what beans I use, so wash with soap after every use. Be sure to know, water will evaporate and also get soaked up in the coffee beans, so adding a little more water above Max may be helpful. Also, pro tip, when you take out the insert with the beans, put it over the lid and tilt it and let it rest for 3 Mins so all the water from the beans pours out, do NOT force it with your fingers as you'll get more grounds and will have a harsh flavor.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 12, 2020
F
Verified Purchase
Faye-Lee Chang
Alexandria, US
★★★★★ 5
Great for iced tea and easy to use
Style: 51oz｜Conical Styles
I use this for making iced tea and it works perfectly. You can use tea bags or loose-leaf tea, and both come out great. It’s easy to fill, strain, and clean, and I like that I can just keep it in the fridge and pour as I go. The airtight seal keeps everything fresh. Super convenient and a staple for my fridge now
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 3, 2025

recommand products

Fire poker, fireplace poker, dragon, medieval, 6th anniversary, iron gift, BBQ, firewood, fire,Christmas,grill,birthday,steel gift,mens gift
150.00
Mini Dress with Organza Ruffle Detail
1237.50
Medieval lock, key, door lock, medieval, door hardware, lock, wedding, Christmas, door handle, door pull, blacksmith, vintage, retro,antique
182.81
Sterling Silver Rhodium Plated Cable Chain (2.20 mm)
56.99
Strapless Dress with Flower Embellishments
780.00