Maretron Current Loop Monitor (For use with 4-20mA Transducers)

Maretron Current Loop Monitor (For use with 4-20mA Transducers)Numerous 4 20mA current loop transducers are supported by the CLM100 including transducers for monitoring DC voltage and current flow rate distance linear velocity and acceleration angle angular velocity and acceleration temperature humidity resistance strain gauges force (load cells) pressure decibels and rotational rate. Some typical applications where the CLM100 is used together with a commercial available 4 20mA transducers include machinery

Numerous 4-20mA current loop transducers are supported by the CLM100 including transducers for monitoring DC voltage and current flow rate distance linear velocity and acceleration angle angular velocity and acceleration temperature humidity resistance strain gauges force (load cells) pressure decibels and rotational rate.

Some typical applications where the CLM100 is used together with a commercial available 4-20mA transducers include machinery monitoring using accelerometers and vibration sensors. Vibration monitoring of pumps motors fans compressors and gear boxes provides an early warning of potential problems resulting fewer breakdowns and reduced maintenance expenses.

Another application example using the CLM100 is shaft speed monitoring. A commercially available 4-20mA rotational rate sensor is coupled to the shaft of interest and the CLM100 converts the transducer data to an RPM that can be read by a compatible NMEA 2000 display. And if you're concerned about the force exerted on a mast stay or perhaps a vessel tow attachment point commercially available clevis pins with a 4-20mA interface can be connected to the CLM100 and the corresponding load monitored using any of Maretron's display products.

The CLM100 is NMEA 2000 certified so you can view any and all information anywhere on the vessel using a compatible NMEA 2000 display. The CLM100 is a key component of Maretron's N2KView vessel monitoring and control system.