Pay in installments of $104.12 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 11 - Aug 16
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Auto Meter Gauge Kit 2 pc. Quad & Speedometer 5in Old Tyme BlackSometimes Space Is Limited. The Autometer Quad Gauge Provides A Solution To Limited Dashboard Space While Providing A Clean Look. Individual Autometer Air Core Meter Movements For Each Function Provide The Accuracy And Durability Required By Even The Most Demanding Applications. Includes A Single Wire 1 8" Npt Temperature Sender And A 1 8" Npt Oil Pressure Sender. The Voltmeter Reads From 8 18V On Negative Ground Electrical Systems And Fuel Level
Sometimes Space Is Limited. The Autometer Quad Gauge Provides A Solution To Limited Dashboard Space While Providing A Clean Look. Individual Autometer Air Core Meter Movements For Each Function Provide The Accuracy And Durability Required By Even The Most Demanding Applications. Includes A Single Wire 1/8" Npt Temperature Sender And A 1/8" Npt Oil Pressure Sender. The Voltmeter Reads From 8-18V On Negative Ground Electrical Systems And Fuel Level Resistance Range Is 240 Ohms Empty To 33 Ohms Full (Compatible With Autometers 3262 Fuel Level Sender).
- Speedometer has a simple push button, 2 mile drive calibration. No dip switches and can be reprogramed at any time to accommodate changes in gear ratio or wheel and tire combination.
- oil pressure sender, water temperature sender, 2-wire hall-effect speed sender that is compatible with GM/Chrysler applications (7/8" - 18THD)
- Autometers Race Proven Air-Core Electric Instruments Provide Quick And Accurate Readings While Keeping Hazardous Fluids Outside Of The Vehicle
- bulb and socket assemblies, red and green bulb covers, mounting hardware, and detailed instructions for installation.
- Speedometer features lit LCD odometer - capable of registering one-million miles with two resettable trip odometers
- 4 in 1 gauge design saves valuable real estate on your dash while allowing you to monitor critical parameters
- Speedometer is compatible with most two wire sine wave and three wire hall effect vehicle speed sensors.
- 12 and 16 volt compatible, compatible with nearly every street car or race car electrical system
- sending unit adapters (1/4" , 3/8" , and 1/2" NPT adapters)
- Kit includes fuel level sender (240E/33F)
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.2 ★★★★★
Based on 25 reviews
Sort
Product Reviews
★★★★★ 4
Easy Install Onto Jeep JKU, No Switch Backlight or Mounting Holes, Great Customer Service
Color: 5in Cube LED Pod, Color: 5in Cube LED Pod
I installed the Auxbeam 5" 168W LED Cube Pods onto my Jeep JKU Anniversary Steel Bumper. It was an easy install with some YouTube videos to help me snake the cables into the cab.
The unused holes in the steel bumper were the perfect size to fit the mounting bolts on the pod lights, and there was plenty of room to reach under the top edge of the bumper to install the nuts with some Loctite.
To snake the provided cable through the firewall, I had to remove the installed socket. This was easy to do by simply recessing the retainer clip on each pin, taking a picture of the wired connector before releasing the wires so I knew how to reassemble, snaking the connectorless cable through the firewall into the cab where the pins were then reinserted and locked into the connector. I dressed the cable by zip tie to the existing wire harness at the top of the engine bay. In the cab, I pulled the side panel from the dash (driver's side) and made a small hole for the cable in the panel. After cleaning the dash with alcohol, the adhesive-backed switch seems to hold nicely in place.
The lights were very bright and did a great job of illuminating the front and sides of the trail ahead of me.
No backlight on the switch, which is a necessity, and I dont understand why that feature is not present.
Also, there is no through hole to mount as the adhesive back won't stay attached, so the lack of a mounting hole is a big negative as well.
5 Month UPDATE: One of the lights got water inside. I noticed two screws that hold the glass cover were loose on the bottom of both sides. The other light also had the same loose screws but no water under the glass. I contacted Auxbeam, and they replaced the entire set in 2 days. Very awesome customer service.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 25, 2023
★★★★★ 5
Brightness and quality
Color: 4*2.5in Cube LED Pod
Got this for my 2024 Crosstrek. Got this one specifically due to its functionality that I wanted, quality for the price and it looks great especially DRL. I leave the Amber cover on most of the time. If you want the DRL to be on while the car is on, you can do that but it has to be rewired which I did. Love the brightness. I’ve been having this on my Crosstrek for a few months now and have no issues.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 3, 2026
★★★★★ 5
Bright lights
Color: 4*2.5in Cube LED Pod
Installed these on my Bronco as ditch lights. Very bright light and I like that you can have them be white or put the cover on them for and amber light look. Took about 30 minutes to install and wire to the upfitter switches. They shoot a wide angle covering your blind spots on dark roads. I got these to replace a three inch ditch light. They're made from heavy duty metal and stand up to the extreme weather. I like them so much that I purchased the seven inch lights and install them on the front bumper. For what they cost it was a price that I couldn't pass up. I highly recommend these lights.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 17, 2026
★★★★★ 5
Great product
Color: 4*2.5in Cube LED Pod, Color: 4*2.5in Cube LED Pod
Great lighting and beautiful design!!!!!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 18, 2026
★★★★★ 5
Great lights
Color: 52Inch Lights +LED Pods+ Wiring Harness, Color: 52Inch Lights +LED Pods+ Wiring Harness
These lights are awesome. Ridiculously bright and cheap. I have nothing to compare them to but they're for being so inexpensive they are tremendously bright for being a first time installer. I cannot speak to their longevity and the moisture as I only put them on a week ago and went on trail. The whistling is definitely kind of a pain. I've tried the double sided tape people mention and it softened the whistle but when you get up to 70 mph it is obnoxiously loud I'll have to tweak it some more. If you're sensitive to loud squeezing sounds it definitely makes the ride a bit uncomfortable and I would look at other light installations instead of the 52 inch bar. If you can get past the squeeling noise or dampen the sound better than I did then you can't beat the functionality for the price
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 4, 2025