Harrison Bass Flow

Harrison Bass FlowAVA Bass Flow is the next in the 'Flow' series plug in line from manufacturer Harrison Consoles; an all in one Bass processing suite AVA Bass Flow is a channel strip plug in designed for mixing bass. It contains 4 routable processing elements and a master section with input, output, and routing controls. The elements included are: Bass Character The Bass Character is a unique EQ that follows the pitch of the note being played, allowing you to boost or

AVA Bass Flow is the next in the 'Flow' series plug-in line from manufacturer Harrison Consoles; an all-in-one Bass processing suite...

AVA Bass Flow is a channel strip plug-in designed for mixing bass. It contains 4 routable processing elements and a master section with input, output, and routing controls.
 
The elements included are:
 
Bass Character

The Bass Character is a unique EQ that follows the pitch of the note being played, allowing you to boost or cut the harmonics within each note and thus alter the actual character of the bass sound.

Spectral Bass Compressor

The Spectral Bass Compressor is a multiband compressor designed especially for bass. It allows for applying compression selectively across 6 frequency bands focused in the lower end of the spectrum where bass notes mainly reside.

Equalizer

The Equalizer module consists of a 5-band EQ with 2 additional filter bands, an Output Trim control, and an optional RTA display. Each band has adjustable Frequency, Gain, Shape, and Q parameters as well as the option to toggle in or out. You can control the bands directly on the EQ Graph or with their corresponding controls below the graph.

Chorus

The Chorus is an effect that can be used to boost overall presence and add extra motion to your bass signal. It has Detune and Delay controls for dialing in the effect and a Mix control for blending it with the dry signal. The Chorus effect adds 2 pitch-shifted voices: one above and one below the input signal.

Master Controls

The Master Control section at the bottom-right corner of the plug-in window contains controls for switching input polarity, adjusting input & output trim, and setting the order of routing between elements.

You can change the routing order by clicking and dragging a routing item to a new position. The arrows show the direction of signal flow from top to bottom.
The "ear" icon buttons to the right of the routing items indicate Router Listen points. These buttons allow you to listen at specific positions along the signal chain by automatically bypassing all modules past the selected point in the routing order.

The Solo/Listen Clear button at the bottom of the Master Control section clears any active Routing Listen point as well as any modules that are soloed. It will light up to indicate whenever either of these are currently active.