GReddy PANDEM RX-7 BOSS TURN SIGNALS (17040313)

GReddy PANDEM RX-7 BOSS TURN SIGNALS (17040313)For use with Rocket Bunny Pandem Version 2 Front Bumper on FR S BRZ, RX 7, 350Z, GT R, S15 and NSX 10 LED DRL Light Kit with controller Basic Wiring Diagram Translation: Black ( ) Ground Red (+) 12V Power Yellow 12V ACC White 12V Positive Headlight Gray 12V to Flash Blinker Brown 12V Blinker Set A LED Green 12V Blinker Set B LED Product description: With ACC at ON position, the light will light up WHITE Corresponding LED will flash AMBER with turn

For use with Rocket Bunny/Pandem Version 2 Front Bumper on FR-S/BRZ, RX-7, 350Z, GT-R, S15 and NSX

10 LED DRL Light Kit with controller

Basic Wiring Diagram Translation:

• Black (-)- Ground
• Red (+)-12V Power
• Yellow- 12V ACC
• White- 12V Positive Headlight
• Gray-12V to Flash Blinker
• Brown- 12V Blinker Set A LED
• Green- 12V Blinker Set B LED

Product description:
With ACC at ON position, the light will light up WHITE
Corresponding LED will flash AMBER with turn signal on
With parking or headlights on, the LED will turn AMBER
It will take roughly 20sec for the LED to turn off after the ACC is turned OFF
* Flash Feature: if you connect the Gray wire to positive terminal, the LED will flash WHITE and AMBER

Input Voltage: DC 9V-24V
Current Draw: 0.7A per unit
Waterproof rating: IP66

* Make sure to check that all the LEDs light up before installation

Detailed Wiring Instructions:

1. Connect the main unit (control box) to the LED(s)
2. Connect the Yellow wire to the Positive batter terminal and the Black wire to the Negative. - LED will light-up WHITE
3. Connect the White wire to Positive battery terminal. LED will light up AMBER
4. Connect the Brown or Green wire to 12V source. Each corresponding LED will light up AMBER
5. If you disconnect the Yellow wire from the 12V source.LED will turn off after 20sec.
6. If you connect the Gray wire to the 12V source while the LED is on - the LED will Flash.