Solid Color Upper Door Spear Stripe Kit - 2021+ Bronco 4 Door (non-Raptor)

Solid Color Upper Door Spear Stripe Kit - 2021+ Bronco 4 Door (non-Raptor)Custom cut vinyl upper door spear stripe kit fills the factory indentation along the upper doors and fenders 9 piece complete set all four doors and fenders covered 13+ color options solid colors, metallic, carbon, plus custom printed available Made in the USA Peel and stick wet install no trimming, no guesswork Fits 2021+ Ford Bronco 4 Door (non Raptor only) Solid Color Upper Door Spear Stripe Kit 2021+ Ford Bronco 4 Door Fill the upper door spear

• Custom-cut vinyl upper door spear stripe kit — fills the factory indentation along the upper doors and fenders
• 9-piece complete set — all four doors and fenders covered
• 13+ color options — solid colors, metallic, carbon, plus custom printed available
• Made in the USA 🇺🇸
• Peel-and-stick wet install — no trimming, no guesswork
• Fits 2021+ Ford Bronco 4-Door (non-Raptor only)

Solid Color Upper Door Spear Stripe Kit — 2021+ Ford Bronco 4-Door

Fill the upper door spear indentation and make it yours. 9 pieces, complete set, wide color selection.

What This Kit Does

The 2021+ Bronco has a distinctive spear-shaped indentation running along the upper doors and fenders — one of the most recognizable design elements on the truck. From the factory it's body-color. This kit fills it with a contrasting or matching vinyl color for a two-tone look that's sharp, intentional, and distinctly Bronco.

9 individual pieces, precision-cut for each door section and fender. Peel-and-stick installation with a wet method — no trimming required, everything lines up to the factory indentation. Made in Fort Myers, FL.

Installation

Clean the application area with a wax-free detailing spray. Install temperature should be around 75–85°F — use a heat gun or hair dryer in cooler weather. Keep the vinyl out of direct sunlight during install. Let it dry fully before driving and check adhesion over the next few trips.

For a wet install, use StickerFab Application Fluid (or a drop of dish soap in a cup of water). Apply to the vinyl so you can slide it into position before it sets — then squeegee out the excess. Painter's tape makes a great alignment guide.

Recommended: Microfiber, detailing spray, application fluid, felt-tip squeegee, heat gun. Grab our 3-item install kit if you need supplies.

Fitment

Fits: 2021+ Ford Bronco 4-Door (non-Raptor). Upper door spear indentation, all four doors and fenders. Does not fit the Bronco Raptor — different body panel profile.

FAQ

Complete the Look

Pair with the lower door spear kit for a full two-spear build on your Bronco.