Victron Phoenix Inverter 24/5000 230V Smart

• Voltage: 24V
• Cont. Output Power at 25°C: 5000VA
• Peak Power: 10000W
• Output AC Voltage: 230V
• Protection Category: IP21
• Efficiency: 95%
• Bluetooth Enabled: Yes
• Dimensions: 595 x 295 x 160mm
• Weight: 29Kg
• Warranty: 5 Years

The Phoenix Inverter 24/5000 Smart is an efficient and reliable inverter. Built on our proven and field tested Phoenix inverter platform it now comes with a new slimmer design and full metal casing. Models are available in 1600VA 2000VA 3000VA and 5000VA for 12 24 or 48V systems.

It’s powerful enough to supply most common plug in appliances in cars boats caravans or in homes. A toroidal transformer provides a high peak power surge capacity stable voltage frequency and high quality sine-wave.

Installation is simpler than ever before with terminals now more accessible for the installer enabling a more professional finish.

Bluetooth is built-in and makes setting up the high power inverter easier than ever before.
Configure alarms alarm relay voltage cut-off output voltage frequency eco-mode and more all from within VictronConnect.

Features

Bluetooth built-in: fully configurable with a tablet or smartphone

• Low battery voltage alarm
• Low battery voltage cut-off and restart levels
• Dynamic cut-off: load dependent cut-off level
• Output voltage: 210 – 245V
• Frequency: 50 Hz or 60 Hz
• ECO mode on/off and ECO mode sense level
• Alarm relay

Monitoring:

• In- and output voltage load and alarms

VE.Direct communication port

The VE.Direct port can be connected to a computer (VE.Direct to USB interface cable needed) to configure and monitor the same parameters.

Proven reliability

The full bridge plus toroidal transformer topology has proven its reliability over many years. The Phoenix Smart Inverters are short circuit proof and protected against overheating whether due to overload or high ambient temperature.

High start-up power

Needed to start loads such as power converters for LED lamps halogen lamps or electric tools.

ECO mode

When in ECO mode the inverter will switch to standby when the load decreases below a preset value. Once in standby the inverter will switch on for a short period every 2 5 seconds (adjustable). If the load exceeds the preset level the inverter will remain on.

Remote on/off

A remote on/off switch or relay contact can be connected to a two pole connector. Alternatively the H terminal (left) of the two pole connector can be switched to battery plus or the L terminal (right) of the two pole connector can be switched to battery minus (or the chassis of a vehicle for example).

To transfer the load to another AC source: the automatic transfer switch

For our low power inverters we recommend our Filax Automatic Transfer Switch. The Filax features a very short switchover time (less than 20 milliseconds) so that computers and other electronic equipment will continue to operate without disruption. Alternatively use a MultiPlus with built-in transfer switch.

Control over system

For perfect control over any system using the Phoenix Inverter 24/5000 Smart connect a Cerbo GX. Simply connect through the Victron Remote Management (VRM) portal or access directly using the separate GX Touch a MFD or the VictronConnect App thanks to its added Bluetooth capability. This latest addition to the GX-range combines all the best of connectivity redefining smart power solutions in every way.