Pay in installments of $32.25 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 4 - Aug 9
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Matek H743-Slim V4 Flight Controller - 30x30mmMatek H743 Slim V4 is a high end flight controller designed for freestyle and long range drones powered by 28S LiPo batteries. It offers wide compatibility with Betaflight, iNav, and ArduPilot firmware. The board is built around the powerful H743 processor combined with two ICM42688P gyroscopes for precise motion data and a DPS368 barometer for altitude measurement. For analog video, it includes an OSD chip and a microSD slot for Blackbox logging.
Matek H743-Slim V4 is a high-end flight controller designed for freestyle and long-range drones powered by 2–8S LiPo batteries. It offers wide compatibility with Betaflight, iNav, and ArduPilot firmware. The board is built around the powerful H743 processor combined with two ICM42688P gyroscopes for precise motion data and a DPS368 barometer for altitude measurement. For analog video, it includes an OSD chip and a microSD slot for Blackbox logging.
What is new on the H743-slim-V4
- Increase the output current of BEC5V from 2A to 2.5A, and raise the filtered VBAT current from 1A to 2A.
- Add TVS protection on Input voltage
- Add protections on more MCU I/O.
- Replace DPS310 with DPS368(environmentally protected against water (IPx8), dust & humidity)
- Other functions, Pins/Pads layout are same as previous board version.
Check out all our 30x30mm Flight Controllers and the rest of our Matek Products!
Betaflight / Inav Mapping Details
ArduPilot Mapping Details
Specifications
- MCU: STM32H743VIH6, 480MHz , 1MB RAM, 2MB Flash
- IMU: Dual ICM42688P
- Baro: DPS368
- OSD: AT7456E (SPI2)
- Blackbox: MicroSD card socket
- 7x Uarts (1,2,3,4,6,7,8) with built-in inversion.
- 13x PWM outputs(including “LED” pad)
- 2x I2C
- 1x CAN
- 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2)
- 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
- 1x SPI3 breakout
- USB Type-C(USB2.0)
- 1x JST-SH1.0_8pin connector (Vbat/G/Curr/Rx8/S1/S2/S3/S4)
- 1x JST-GH1.25_4pin connector (5V/CAN-H/CAN-L/G)
- Dual Camera Inputs switch
- 5V 0r Vbat(2A) filtered power ON/OFF switch
- DJI FPV OSD is supported by any spare UART
Power
- Vbat Input: 6~36V (2~8S LiPo) with TVS protection
- BEC: 5V 2.5A cont. (Max.3A)
- LDO 3.3V: Max.200mA
- VBat filtered output 2A for VTx and camera
- No Current Sensor built-in
- ADC Vbat2 pad supports Max. 69V (voltage divider: 1K:20K)
- Static power: 200mA@5V with Betaflight, 150mA@5V with ArduPilot
FC Firmware
- ArduPilot: MATEKH743
- BetaFlight: MATEKH743
- INAV: MATEKH743
Physical
- Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
- Dimensions: 36 x 36 x 5 mm
- Weight: 7g
Package Includes:
- 1 x H743-SLIM-V4
- 6 x Silicon grommets M4 to M3
- 1 x JST-SH1.0_8pin cable, 5cm
- 2 x JST-SH1.0_8pin connectors
- 1 x JST-GH-4P to JST-GH-4P cable for CAN port, 20cm
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.6 ★★★★★
Based on 19 reviews
Sort
Product Reviews
★★★★★ 3
A familiar story, just with…..less.
Format: Kindle
So, as other reviewers make clear, this is very similar to Pack Darling and The Beta. It’s much closer aligned with The Beta, in plot and maybe more like Pack Darling with characters.
That being said, I don’t hate this…..but it wasn’t great either. It’s both books mentioned but just….less. Less angst, less emotion, less feeling. The plot feels very half fleshed out, and the “bad guy” feels underwhelming. I didn’t really feel any real emotions from and of the male leads, except maybe Oliver. The others fell sorta flat for me. And Mika makes herself out to be this big bad ass straight outta training and then we never see it from here again with the one fitting room incident as the exception.
SPOILER:
The whole, “Oh, I’m actually probably an Omega, but I don’t wanna be but I do actually wanna be but no one can ever know my secret that I do nothing to hide “ thing fell so flat. She never commutes to believing she was secretly an omega, but also mentions her “secret” a lot. It just felt so manufactured.
I’m intrigued enough to read part 2 and see how the author closes everything out, but this is not one I’ll recommend or ever come back to.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 13, 2024
★★★★★ 5
Good start to a series
Format: Kindle
I delayed reading the series for reasons I don’t remember. But my TBR list is huge so I thought I’d take a shot of this and I was pleasantly surprised. I didn’t think the blurb about it was anything special. But it was a very good book. It took some interesting twists and turns. I am so glad the second book is already out. Because I would not have waited patiently. Very slow burn but good storyline. 🔥🔥/5
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 3, 2025
★★★★★ 4
A good read
Format: Kindle
Multiple points of view. 3 Alpha men and an Omega male. She is a Beta in training for a new program placing betas in Alpha/Omega packs. Mila is only doing the program for the money to take care of her dad. She wasn't expecting to fall for a pack but when she sees this packs Omega she is done for. There is just something about him. His Alphas are good looking as well. Too bad she is hiding a secret and their government is acting shady. I liked it and can't wait to see where their story goes.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 14, 2023
★★★★★ 3
Slightly repetitive but I did love some things
Format: Kindle
I love this type of story. And omegaverse is one of my all time favorite genres. But there are a few things that pulled me out of my enjoyment while I was reading. It was repetitive at times as well as struggled with telling not showing. So we didn’t always feel like we were experiencing things with the main character. There were also some plot holes but they may still be answered in part 2.
Now this isn’t to be said I didn’t enjoy parts of the story. I loved the almost instant love between Mila and Oliver. And how he started changing around her.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 15, 2024
★★★★★ 5
delightful read
Format: Kindle
What a delightful read. The characters are awesome, the plot was so good, I loved it. I was intrigued and it kept me wanting more. Told in multiple pov, the book sucks you in and doesn’t let go. I cannot wait to read the next book.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 30, 2025