SKU: 91643934411

Fits Toyota Tundra 2WD/4WD (2007-2021) 2.5-3 Inch Leveling Kit; 870

$116.95 $129.95
Save 10%
No.2 Bestseller on salfueradeti.es >

Pay in installments of $32.49 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 17 - Jul 22

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Fits Toyota Tundra 2WD/4WD (2007-2021) 2.5-3 Inch Leveling Kit; 8702. 5 3 Inch Leveling Kit Toyota Tundra 2WD 4WD (2007 2021) Rough Country's 2. 5" 3" Leveling Suspension Kit for Toyota Tundra is the most innovative way for you to level the front of your vehicle with the rear, allowing you to dial in the angle you desire. Featuring a set of front, upper strut extensions, this kit can accommodate up to a 33" tire. This kit now includes two sets of 0. 25" spacer shims, which can be used in addition to the strut spacers

2.5-3 Inch Leveling Kit - Toyota Tundra 2WD/4WD (2007-2021)

Rough Country's 2.5" - 3" Leveling Suspension Kit for Toyota Tundra is the most innovative way for you to level the front of your vehicle with the rear, allowing you to dial in the angle you desire. Featuring a set of front, upper strut extensions, this kit can accommodate up to a 33" tire. This kit now includes two sets of 0.25" spacer shims, which can be used in addition to the strut spacers to fine-tune your level angle. Each shim provides roughly 3/8" of lift. Use both for a full 3" level, or fewer to leave a little rake in the front end angle - this is specifically great for individuals who prefer a slight nose down look for an aggressive head-on view, or routinely pull trailers and haul items that would potentially draw the nose up from a full level stance. Designed by Rough Country's in-house Research and Development team, these components are engineered for a precise fit and incorporate superbly with factory equipment. A set of skid plate spacers allow use of the stock skid plate, and all components are easily removable should the vehicle need to be returned to stock height. A set of differential spacers help maintain factory ride quality, promoting optimum angles for the front CV axle after lifting. 100 % bolt-on installation makes setup a breeze, and all components are protected by Rough Country's Lifetime Replacement Warranty.


Features:

  • Easy bolt-on installation
  • Increased ground clearance
  • Maintains factory ride quality
  • Levels the front with the rear of the vehicle
  • Differential spacers maintain proper front CV axle angle
  • Strut spacer kit requires no strut disassembly or strut compressor for installation.(870)
  • Strut spacer kit features adjustable shim plates that allow you to fine tune the front amount of lift. (870)

Application:

Year Make Model Submodel
2007-2013 Toyota Tundra Base
2007-2021 Toyota Tundra Limited
2007-2021 Toyota Tundra SR5
2013-2021 Toyota Tundra Platinum
2014-2021 Toyota Tundra 1794 Edition
2014-2021 Toyota Tundra SR
2021 Toyota Tundra Nightshade
2021 Toyota Tundra Trail
Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 91643934411

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.2 ★★★★★
Based on 14 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
M
Verified Purchase
Movie Fan
Fort Morgan, US
★★★★★ 3
Nice Edger as long as the blade doesn't come loose -- and it will come loose, repeatedly!
Probably could've/should've rated this 2 stars yet it works well when it works. I purchased this edger to edge my drive and sidewalks and not for trenching. The edger arrived very quickly after I ordered it (I am not a Prime member so this was a nice surprise). Assembly was easy and straight-forward. The first use went smoothly and the edger performed flawlessly and provided clean, smooth edging. About 20 minutes into the second use I noticed that the edger was cutting and quickly determined that the blade was spinning freely -- fortunately the hex nut was still attached to the threaded shaft. I reviewed the manual that came with the edger, grabbed the correct sized socket and torque wrench. I removed the hex nut, the first washer, the blade and then the second washer. To install I followed the directions ensuring that the flats of the washer aligned with the flat on the shaft and tightened the hex nut to the specified 140 in-lbs. The edger worked well for about 10 minutes and the blade once again became loose. This time I replaced the original blade (which did not need to be replaced from a wear perspective) with a new B&D blade and new washers. Once again I followed the instructions and this time the edger performed flawlessly until about 5 minutes remaining in my edging when once again the blade came loose. my experience has most certainly been frustrating to say the least. one should not need to carry a socket and torque wrench with them and repeatedly need to tighten the blade. So, when the edger performs as intended it does an excellent job at edging; however I have no confidence that this edger will be able to perform as intended throughout repeated uses and more importantly has shown that it cannot complete my edging without requiring tightening the blade (which requires disassembly down to the second keyed washer). Potential buyers should be prepared for this experience and make your decision accordingly. Note: I tried contacting black and decker via twitter (@blackdeckerhome) and never received a response; I could not find a separate customer service/support twitter account. Trying to contact customer service via the phone these days is an exercise in patience to say the least.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 11, 2022
R
Verified Purchase
Robert S.
Bozeman, US
★★★★★ 5
Trimmer results
Was alittle hesitant with this being B&D But I was surprised how great it really is. By far way above my expectations. Works like a charm and does a great job. Chose electric because I really don't have other than a driveway to do. But it really did good around the flower beds. Cord limits you alittle but nothing to cry about. Quiet also but still use ear plugs.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 9, 2026
C
Verified Purchase
Charles H. Pretti Jr.
Phoenix, US
★★★★★ 5
Light weight and very functional
Incredibly light and functional, this trimmer forks with either string or resin blades. I personally prefer the blades. At the time I bought the unit I couldn’t locate replacement resin blades. I finally called Black and Decker and they sent me two packages of the replacement blades for free! The shield keeps trimming from being a messy horror show. No more back soreness because of the ligh weight of the unit. I’m very pleased with both the product and Black and Decker.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 22, 2025
T
Verified Purchase
Tatiana Lema
Port Orchard, US
★★★★★ 5
Espectacular
Es genial, tiene una potencia grandiosa. Me encantó, la recomiendo 100%
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 22, 2026
S
Verified Purchase
Sparklez
Phoenix, US
★★★★★ 4
Needs improvement
This trimmer really looks nice and it comes with some great attachments but what I found is that if you're going to switch from the line attachment to the little plastic attachment you have to sit somewhere where you can lay the item down because you have to unscrew one to put on the other. There is no way to easily switch from line trimming to attachment trimming without using the device that unhooks the screw. In my opinion that is really a detriment to the beauty of the overall working of this item the weight of it is good, it cuts good it automatically feeds the line out the color is nice and the price is great but then you have the issue of changing the line back and forth if this was improved I think I would definitely give it five stars I'm sorry but improvements need to be made.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 14, 2025

recommand products

SanDisk Max Endurance 64 GB UHS-I Class 10 MicroSDXC Memory Card
81.58
SanDisk Max Endurance 128 GB MicroSDXC UHS-I Class 10
105.71
Philips All-in-One Trimmer 9000 Series MG9531/15 15-in-1 Trimmer
117.78
REBEL ACTIVE TRAMPOLINE PRO 15FT/457CM
158.34
Razer BlackShark V2 X - Headset - 7.1 channel - full size - wired - 3.5 mm jack - noise isolating - white
85.95