Foam Cannon Pro V2.0 for Bennett Read, Lavor, WAP & Parkside

Foam Cannon Pro V2.0 for Bennett Read, Lavor, WAP & ParksideCompatible with below Pressure Washer Models: Lavor Pressure Washers Parkside Pressure Washers Kamran Enterprises Pressure Washers ResQTech Pressure Washers WAP Pressure Washers Whats New with the New Generation Foam Cannon Pro V2. 0: 360 Degree Spray Patterns. Easier to foam the top and chassis of your vehicle. Better Foam Fan. New Generation Foam Technology. Thicker foam with less shampoo. Up to 30% thicker foam. Less noise. Works with as low as

Compatible with below Pressure Washer Models:

• Lavor Pressure Washers
• Parkside Pressure Washers
• Kamran Enterprises Pressure Washers
• ResQTech Pressure Washers
• WAP Pressure Washers

What’s New with the New Generation Foam Cannon Pro V2.0:

1. 360 Degree Spray Patterns.
2. Easier to foam the top and chassis of your vehicle.
3. Better Foam Fan.
4. New Generation Foam Technology.
5. Thicker foam with less shampoo.
6. Up to 30% thicker foam.
7. Less noise.
8. Works with as low as 90Bar(1300Psi) pressure washers.
9. New Connection/Fitting.
10. Easier and faster to attach fitting, no need tape or glue.
11. New Tank and Cap.
12. More than 1Liter capacity to wash bigger vehicles.
13. Easier to attach with foam cannon body.
14. Tank cap is leak proof even when you put upside down.
15. More stable, robust, and durable.

Before Purchasing the MJJC Foam Cannon Pro V2.0, Please Ensure the Following:

 1. Check Your Pressure Washer's Operating Pressure

 Your pressure washer must operate at a minimum of 50 BAR/725 PSI.

 Each Foam Cannon Pro V2.0 comes pre-installed with a 1.25mm orifice, which is ideal for machines rated 110 Bar/1595 PSI ~ 150 Bar/2175 PSI.

 A 1.1mm orifice is included in the package. If your machine operates 90 Bar/1305 PSI ~ 110 Bar/1595 PSI, you can replace the original orifice with the 1.1mm version for better compatibility.

 If your pressure washer falls outside these two ranges, please refer to the below range to purchase the correct orifice size for optimal performance.

 What is the pressure range for each orifice?

· 0.9mm orifice: for 50 Bar/725 PSI ~ 90 Bar/1305 PSI pressure washer

· 1.1mm orifice: for 90 Bar/1305 PSI ~ 110 Bar/1595 PSI pressure washer

· 1.25mm orifice: for 110 Bar/1595 PSI ~ 150 Bar/2175 PSI pressure washer

· 1.35mm orifice: for 150 Bar/2175 PSI ~ 280 Bar/4061 PSI pressure washer

· 1.65mm orifice: for 280 Bar/4061 PSI ~ 340 Bar/4931 PSI pressure washer

2.Confirm Your Pressure Washer Type

This foam cannon is designed for use with Cold Water pressure washers only. It is not compatible with hot water machines.