Pay in installments of $45.00 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 22 - Jul 27
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
DINITROL CAVITY WAX RUST PROOFING KIT LITRES SMALL FIESTA CORSA MINI MGBGT DIN34DINITROL ML was developed for use in closed cavities such as doors, frame parts and external hinges and gaps. The product can be used as corrosion protection for used cars, trucks, buses and other vehicles. BenefitsBrownExtremely PenetratingStops ongoing corrosionWater displacingOily, flexible filmWet in wet with bitumen vehicle Underbody coatingApplicationDINITROL ML is designed for application into closed cavities such as doors, frame members and
DINITROL ML was developed for use in closed cavities such as doors, frame parts and external hinges and gaps. The product can be used as corrosion protection for used cars, trucks, buses and other vehicles.Benefits
Brown
Extremely Penetrating
Stops ongoing corrosion
Water displacing
Oily, flexible film
Wet in wet with bitumen vehicle Underbody coating
Application
DINITROL ML is designed for application into closed cavities such as doors, frame members and exterior joints and crevices. The product can be used for rust-proofing of second-hand cars, trucks, buses and other vehicles. Application temperature should be between 15 and 30°C.
Method of use
DINITROL ML is applied by spraying with manual or semi-automatic.
DINITROL application equipment, and is suitable for either air-mixed or airless spraying.
Pre-treatment Substrates
DINITROL ML is possible to apply on mois and corroded surfaces. For the best result, loose corrosion shall be removed before application.
Over-Coating / 2-Layer-Application
DINITROL ML can be over-applied with any of the DINITROL bitumen underbody coatings. For additional information, please consult DINOL GmbH.
Storage
The product shall be stored at 15 ? 30°C and the shelf life is then 2 years in unopened original packages.
Technical Data
Colour brown
Type of film oily, greasy
Density at 23°C 860 kg/m³
Viscosity at 23°C, (DIN 2) 60 seconds
Dry matter content 46% by weight
Flash point 40°C
Aromatic content in solvent < 1 %
Recommendes film thickness 10 ?m
Recommended film thickness wet 30 ?m
Drying time 1 hour
Heat resistance 80°C
Low temperature adhesion < - 40°C
Salt spray test > 96 hours
Penetration in 50 ?m wide gap > 70 mm
Effect on car paint none
Removability White Spirit
Available in 1 L Miniservice / 5L Pail / 20 L Pail
60 L Drum / 208 L Drum / Container
DINITROL 4941 / 4941 CAR is a long term protective product. The product leaves a firm, black film with short drying time and good adhesion and flexibility on all metal surfaces, rubber and plastic parts.
Benefits
OEM references
Robust universal film
Self-healing
Easily applied
Good abrasion resistance
Component protection
Applications
DINITROL 4941 / 4941 CAR is an underbody product or use in the treatment of vehicles during production, at import plants and in aftermarket applications. When applied to a clean, dry surface, it adheres to both painted surfaces and those coated with a layer of PVC or similar material. Zinc, rubber and plastics are completely unharmed by the product.
A clean and economic treatment on the line is assured by the products ease of application and high dry matter content. DINITROL 4941 / 4941 CAR is also designed for use on spare parts, machines and iron and steel structures in highly corrosive environment. DINITROL 4941 / 4941 CAR is also very suitable as an anticorrosive coating for transport and warehousing under extremely corrosive conditions.
Method of use
DINITROL 4941 / 4941 CAR can be applied by manual or automatic application equipment, airless or airmix.
Recommended application and product temperature is 15 ? 30°C.
Pre-treatment Substrates
DINITROL 4941 / 4941 CAR can be applied directly to clean, dry and corrosion-free surfaces.
If corrosion is present, DINITROL ML or a DINITROL cavity wax shall be applied before.
Over-Coating / 2-Layer-Application
DINITROL 4941 / 4941 CAR can not be over-painted.
For additional information, please consult DINOL GmbH.
Technical Data
Colour - black
Type of film - hard, waxy
Density at 23°C - approx. 1100 kg/m³
Viscosity at 23°C - 800 mPas
Dry matter content - 69% by weight
Flash point - 36°C
Aromatic content in solvent - 0,5%
Recommended film thickness wet - 700 ?m
Recommended layer thickness - 300 ? 500 ?m
Drying time - 6 ? 12 Stunden through dry
Low temperature adhesion - -20°C
Removability - Hydrocarbon solvents
Heat resistance - 130°C
Salt spray resistance, 300 ?m - 1500 hours
DINITROL RC 900 is a rust converter based on organic chelate complex combined with epoxy resin. It actively converts the rust on the substrate into a stable organic iron complex. When the product dries, it forms an impenetrable barrier to further corrosion. DINITROL RC 900 penetrates about 7?10 times deeper into the rust than conventional rust conversion products and forms a dry and strong adhesive film that is suitable as a base for the lacquer structure and as a carrier for other corrosion protection products.
Benefits
Polymer film formed on converted rust
Deep effect
Easy application
Deep working properties
Overpaintable
Applications
DINITROL RC 900 is designed for use on oxidized iron parts.
Method of use
Remove rust, grease and dirt with a wire brush, sand paper or a sandblasting process. Rust and scale may only be visible as slight shading. In addition to rust, the steel must also be free from dust and grease. Carefully clean with acetone or lacquer thinner. Shake the spray can well. The product should be applied in several successive coats, at a distance of approx. 25 cm.
The metal temperature should not be below 10°C. The material is dust-dry after one hour, if necessary, a further coat can be applied.
Pre-treatment Substrates
DINITROL RC 900 should be applied to corroded surfaces. Loose rust must be removed before processing.
Over-Coating / 2-Layer-Application
DINITROL RC 900 can be overapplied with most DINITROL Corrosion Prevention products and with most common complete paint systems. For additional information, please consult DINOL GmbH.
Technical Data
Colour amber-coloured
Appearance solution
Film type hard
Density 0,9 g/cm3
Viscosity 118 cSt
Solids 16%
Recommended film thickness 130 µm
Yield ~ 60 g/m² per coat
Drying time 24 hours at 20°C
Storage time 10 years (between 15°C and 25°C)
Avaialable in 400 ml Spray
Kit contains:
2 x 1 litre DINITROL ML Cavity Wax
3 x 1 litre DINITROL 4941 Black Underbody Wax
1 x 400ml Aerosol DINITROL RC900 Rust Converter spray
Spraygun with Schutz fitting + 500mm hose & nozzle
25 x 10mm black tapered plastic blanking plugs
Extension Spray nozzle (600mm long) for Aerosol can
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.5 ★★★★★
Based on 26 reviews
Sort
Product Reviews
★★★★★ 4
Good product. Know the limits.
Size: 6 Inch, Style: Open
These are very nice. Sure beats drilling holes in your steel.
However, 45lb is a stretch. Will easily hold 25lbs. However 35+ is a stretch, especially if your walls shift a little due to be close to a door. Will definitely order more, just important to understand the limits. Thanks.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 21, 2026
★★★★★ 5
Finally, a product that meets all of its advertised claims!
It seems to me like this product is always out of stock. Of the ones I have received and been able to use. They work as advertised and hold an incredible amount of weight. It is very easy to put them on and off, but once they are latched down, you could not remove them by hand without bending the hooks I would like to have a few more boxes to use in my steel building.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 13, 2026
★★★★★ 5
Magnet hooks you need!
Size: 4.5", Style: Open
I have been using these all over our shop and helps keep chords, tools and other items off the floor and more organized. I like the ease of the magnet, and it looks like. Built to last. I wish they were not so expensive.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 9, 2026
★★★★★ 5
Great product
Size: 4.5", Style: Open
Strong grip
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 18, 2026
★★★★★ 5
Classy gift for men.
I gifted this beautiful leather organizer to my BF last year for Xmas. He loved, it is functional and storage his belongings at reach and looks very nice.
Very good quality and affordable.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 8, 2024
recommand products
Corsa 2015-2020 Chevy Tahoe/GMC Yukon Cat-Back Exhaust Sport 3in Single Side Twin Polished 4in Tips
885.00
Arches national park print Canyonlands park
92.00
Faria Oil Pressure Sender 1/8 NPTF America 80 PSI Dual Station Standard
59.97
Corsa 2014-2021 Jeep Grand Cherokee Summit Edition Black 2.5in Dual Rear Exit Cat-Back Exhaust
1274.99
Triple Pendant in Brass + Sphere IV
310.00