Stop Preformed Thermoplastic Road Marking

Stop Preformed Thermoplastic Road MarkingOur Stop Sign preformed thermoplastic road marking is one of many quality road markings that we supply. Commonly used in areas where visibility at junctions is low, at junctions onto busy major roads and in car parks, this surface marking highlights to road users that they must stop before proceeding past an accompanying stop line. Combine this marking with the post mounted stop sign to really enforce the highway code to road users. Post mounted signs

Our ‘Stop Sign’ preformed thermoplastic road marking is one of many quality road markings that we supply. Commonly used in areas where visibility at junctions is low, at junctions onto busy major roads and in car parks, this surface marking highlights to road users that they must stop before proceeding past an accompanying stop line.

Combine this marking with the post mounted stop sign to really enforce the highway code to road users. Post mounted signs can be found in our signage section here.

Key Features:

• Easy Application - No special knowledge, talent or years at art school required, just a clean surface and a gas burner. Just place the marking bead side up and apply heat till fully melted onto the surface.
• Professional Appearance - These markings always look good due to their pre-cut design.
• Fast To Install - Minimal surface preparation is required for these markings, with a worst-case scenario requiring an application of primer.
• Non-Slip - No need to apply glass bead to these markings as it comes embedded in them.
• Conforms - BSEN 1871