MACE IGNITION SERVICE KIT TO SUIT HOLDEN STATESMAN WM ALLOYTEC LY7 3.6L V6

MACE IGNITION SERVICE KIT TO SUIT HOLDEN STATESMAN WM ALLOYTEC LY7 3.6L V6The cause of an irregular misfire or a stumble under load may be due to a failed component of the ignition system. This service kit includes everything required to freshen up the ignition system on your Alloytec V6. Unfortunately, lifting the intake manifold is necessary to access the spark plugs and coil packs but this kit has you covered by including a high quality inlet gasket too which, given the age of the car, will mostly likely need to be

The cause of an irregular misfire or a stumble under load may be due to a failed component of the ignition system.

This service kit includes everything required to freshen up the ignition system on your Alloytec V6.

Unfortunately, lifting the intake manifold is necessary to access the spark plugs and coil packs but this kit has you covered by including a high quality inlet gasket too which, given the age of the car, will mostly likely need to be replaced anyways.

The coils in this kit come with a 3 year/100,000km parts only warranty.

Specifications:

• Gap setting (spark plug): 1.1mm

Contents:

• Upper gasket
• Spark plug
• Ignition coil

Vehicle Fitment Guide

Notes:

• It is recommended if you have a VZ that is newer than 07/2006, please check to make sure your current coils match the electrical plug connector in the image above. If you are unsure, please contact us for further assistance.
• A Mace ignition service kit with ignition coils for VZ series till 07/2006 can be purchased through another listing.
• You can contact us if you are unsure about fitment.
• Gap the new spark plugs as recommended in the above fitment guide or car owner's manual. Use a feeler gauge to measure the gap between the center and ground electrode. The gauge should pass through snugly but easily. If too lose or too tight, reset the gap.
• The image is for illustrative purposes only.