ACP-PC-2A Aerobic Control Panel

ACP-PC-2A Aerobic Control PanelKey Features Specs Warranty Aerobic Septic Clock Timer Control Panel Dual Light *Discontinued* This panel has been discontinued, but has been replaced with an upgraded panel, please see below link. https: www. wholesalesepticsupply. com products aerobic septic clock timer control panel e4l Overview: The ACP PC 2A is designed to operate an aerobic treatment unit. This control panel will power one rotary or linear air compressor and one effluent pump.

• Key Features
  
• Specs
• Warranty

• Aerobic Septic Clock Timer Control Panel Dual Light *Discontinued*

  
  

  This panel has been discontinued, but has been replaced with an upgraded panel, please see below link.

  https://www.wholesalesepticsupply.com/products/aerobic-septic-clock-timer-control-panel-e4l

  
  

  Overview:

  The ACP-PC-2A is designed to operate an aerobic treatment unit. This

  control panel will power one rotary or linear air compressor and one

  effluent pump. The control will monitor the water level and system air

  pressure. There will be a 360 degree top mounted red light for high water

  conditions and a 360 degree top mounted amber light for low air pressure

  conditions. There is a piezo electric buzzer in the door of the enclosure.

  The 20 Amp pump circuit breaker will supply a 120VAC single phase 1⁄2 HP

  or smaller pump. The pump operation is controlled by a Grasslin Pin Timer.

  With this timer the pump can be operated on 15 minute intervals at any

  time of the day. This type of system is used mainly for night time aerobic

  spray operation where you only want the pump to operate during certain

  hours. The 10 Amp air compressor circuit breaker will power one rotary or

  linear air compressor continuously. The 10 Amp alarm circuit breaker will

  power the alarm circuit. The High Water alarm is designed to be used with

  a normally open float switch. When the high water float switch raises the

  red alarm light and buzzer will activate. A standard 1 PSI pressure switch is

  included in the control that will monitor the system pressure. The

  Normally Closed contact of the switch should be used and anytime the

  pressure of system drops below 1 psi, the amber alarm light and buzzer

  will activate. There are alarm test and buzzer silence switches mounted in

  the door of the enclosure.

  
  

  The enclosure has a NEMA rating of 4X which provides protection from

  falling dirt, falling liquids, hose directed water and corrosive agents.

  The 10”x8”x4” enclosure is made of Polycarbonate and has a hinged

  lockable door with latches and included screws to secure the door if

  required. All electrical components are mounted inside the enclosure on

  an aluminum back plate.