Wasser-Stopper Pop-Top Rainfly [Vanagon]

Wasser-Stopper Pop-Top Rainfly [Vanagon]Rain can catch even the most prepared campers by surprise, and it's no fun going home early or having a soaking wet tent next to you while you sleep. We designed this product to function similar to any camping tent rainfly. Our rainfly is constructed of silver reflective urethane coated polyester. The waterproofing will keep the rain from direct contact with your pop top tent*, and the reflective silver offers the additional benefit of cooler internal

Rain can catch even the most prepared campers by surprise, and it's no fun going home early or having a soaking wet tent next to you while you sleep. We designed this product to function similar to any camping tent rainfly.

Our rainfly is constructed of silver reflective urethane-coated polyester. The waterproofing will keep the rain from direct contact with your pop-top tent*, and the reflective silver offers the additional benefit of cooler internal temperatures when the sun peeks out. Additionally, the rainfly will also act as an extra layer of insulation like a windbreaker jacket. So go ahead and pop the top like a boss! As an added bonus, we have designed it to completely cover the pop-top luggage rack to create a nifty vestibule storage area. Just zip down the front screen on your pop-top tent, and toss that bulky gear "outside"!

So, whether you're faced with frigid winds, sideways rain, or sleet and snow, this product offers excellent all-weather, year-round performance.

*While we can't guarantee that this product will keep the pop-top tent, the interior of your camper, or the contents of your camper 100% dry, our testing has shown that it provides a high level of weather protection when it comes time to pop that top!

Step-by-step instructions and hardware are included. Let it rain! 

Installation

Note: This rainfly is for all Vanagon Westfalia pop-tops from 1980 - 1991. It is not designed for aftermarket tops such as Riviera, or Country Homes Campers.

This product requires drilling and permanently installing five male snap heads into your fiberglass pop-top. If you are not willing to drill holes in your pop-top, this product will not function properly and should not be purchased. The initial installation is easiest with two people familiar with a tape measure and will take roughly 1 to 2 hours. Once the initial installation has been performed, the rainfly can be set up in the field in under 5 minutes.

It folds up into a small stuff sack that measures 13.5W x 17.5L. The fly attaches along the top (front and sides) with snaps that you install yourself. This requires drilling 5 small 1/8" holes along the inside leading edge of the pop-top itself to attach male snap-in points. This is not visible when the lid is shut, nor does it affect any weather-proofing of the top seal. Along the sides, it uses 1" tabs attached to existing screws for late model tents 1985-1991. Early tents 1980-1984 require adding 2 screws on each side. The bottom front attaches in one of two ways: with webbing and a buckle clip through the cab (snaps near rear view mirror) inside the van, or with add-on long hook straps that can be run down to attach at the bumper or bottom corner of the van. Rain gutter clips hold it on along the sides with another buckle clip in the rear to tension it up.

Step-by-step instructions and hardware are included. Drill and drill bit not included. Let it rain!

PDF Instructions

Wasser-Stopper Installation Instructions