Impact Triple-Flash Hot-Shoe Adapter Mount Kit

B&H has put together this Impact Triple-Flash Hot Shoe Adapter Kit to give photographers the opportunity to create a 3-light setup from their shoe-mount flashes for triple the power. The kit comes with an FA-300HS Triple-Flash Hot Shoe Adapter Mount and a tilting, swiveling Umbrella Mount. The Umbrella Mount has a 5/8" receiver for a light stand and a large handle for tilting as well as an umbrella receptacle. With the Triple Mount fixed to the Umbrella Mount, you can support up to three shoe-mount flashes.

• Impact FA-300HS Triple-Flash Hot Shoe Adapter Mount

  The FA-300HS Triple-Flash Hot Shoe Adapter Mount from Impact allows you to mount, sync and fire up to three flashes from this single adapter. You can fire the flashes at full power for greater light output or, for faster recycle times, fire them at half power to conserve the energy. This unique adapter features a female 1/4"-20 thread for universal mounting, and may be combined with an umbrella or other similar lighting accessories (all sold separately).
  
  The mount has a 3.5mm jack that allows you to use a sync cord to connect the adapter to your camera or wireless receiver. If you own an Impact PowerSync DC Radio Slave System or a similar wireless unit, you can fire them all with a single receiver attached to the adapter. While not designed for use with high-voltage flashes, you can mix and match flashes from most major digital camera manufacturers without issue - though the electrical requirements should always be considered beforehand.

  Mount and sync three different shoe-mount flashes with a single bracket, and fire all three with a wireless receiver. You can also mix and match flashes from most major digital camera manufacturers.

  The adapter has a female 1/4"-20 thread for universal mounting, and a 1/8" (3.5 mm) jack for a sync cord or wireless receiver.

  UPC: 847628552586
• Impact Umbrella Bracket

  The Impact Shoe Mount Umbrella Bracket is a versatile bracket that will fit on almost any light stand. It includes two removable, reversible studs to adapt to light stands with top studs smaller than the standard 5/8". This bracket tilts and swivels to make aiming the light or flash easy. It also includes a cold shoe mount, which will accept virtually any shoe-mount flash unit (except Minolta/Sony).

  Note: Not compatible with Nikon SB-900, SB-910, or Canon 600EX-RT. As an alternative, please see Impact #9101880.

  Two Removable Studs

  The provided studs can be removed from the interior of the bracket by totally loosening the wing knobs and letting them slide out. These studs can be used to mount the bracket to a 1/4"-20 (standard) and 3/8" threaded stand or tripod tops. One stud is used for the flash shoe. The shoe may be unscrewed from this stud.

  Top Swivel Section

  Identified by the small round umbrella socket and locking knob

  Bottom Section

  Contains the locking swivel lever

  Vertical Or Horizontal Use

  Once the stud is removed, the bracket may be mounted vertically, or horizontally out from the top of almost any stand with a 5/8" (Baby) top.

  UPC: 847628010819